KNAKI
latex clown nose
long nose and a little crooked
Clown nose with professional character in latex, handcrafted from tinted rubber.
it is flexible and very pleasant to wear.
washable with soapy water
dimensions:
width 45mm / 1.77"
depth 60mm / 2.36"
height 40mm / 1.57"
The elastic fastener is translucent.
the nose comes in a nice little personalized case.
For all specific orders contact:
legaragefourgon@gmail.com
professional website: www.legaragefourgon.fr
facebook @legaragefourgon
instagram @legaragefourgon
KNAKI
SIZE
To find the right clown nose, you need to take the time to measure your nose, particularly in width and depth.
width (mm): between the 2 wings of the nostrils
depth (mm): wing from nostril to tip of nose
height (mm): from base to bridge of nose
other measurements are indicated when the nose has a greater amplitude.
CONSERVATION
Clown noses are made from mass-dyed latex.
Latex is a soft and comfortable natural material that is sensitive to light.
Under the effect of light, colors become denser over time, however red is the most stable color.
It is therefore advisable to keep clown noses away from light in their small box when they are at rest.
The satin noses are covered with a layer of paint and do not change color.
CLEANING
It is possible to clean latex noses with lukewarm water. Be careful, do not use hydroalcoholic gel or alcoholic solvents.
NYLON ELASTIC THREAD
it can be replaced using a needle with a large eye,
pass the needle 5 mm from the edge to avoid tearing the latex.
SEPTUM (+6 euros):
open ring system
which allows the septum to be held on the nose without any visible thread by pinching between the 2 nostrils.
The septum is made of plastic, so you don't have to spread it too far to place it between the nostrils, which could cause it to break.
The septum is interchangeable: use liquid soap to slide the new septum into the latex.
A thread is always supplied in the box, just in case.